Safety And Warning Information; Safety Guidelines; Important Safety Instructions - Campbell Hausfeld PW2575 Manual Del Producto

Safety and Warning Information

Safety Guidelines

This manual contains information
that is very important to know and
understand. This information is
provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help
recognize this information, observe the
following symbols.
danger indicates
an imminently
hazardous situation which, if not
avoided, wIll result in death or serious
injury.
warning indicates
a potentially
hazardous situation which, if not
avoided, Could result in death or
serious injury.
Caution indicates a
potentially
hazardous situation which, if not
avoided, MAy result in minor or
moderate injury.
notice indicates
important
information, that if not followed, may
cause damage to equipment.
Note: Information that requires special
attention.

Important Safety Instructions

Save tHeSe INStruCtIoNS
When using this product, basic
precautions should always be followed,
including the following:
1. Read all instructions before using
the product.
2. To reduce the risk of injury, close
supervision is necessary when the
product is used near children.
3. Follow all safety codes as well as the
Occupational Safety and Health Act
(OSHA).
4. Ensure safety devices are operating
properly before each use. DO NOT
remove or modify any part of the
gun or unit.
5. Know how to stop this product
and bleed pressure quickly. Be
thoroughly familiar with the
controls.
6. Stay alert – watch what you are
doing.
7. Do not operate the product when
fatigued or under the influence of
alcohol or drugs.
8. Keep operation area clear of all
persons.
9. Do not overreach or stand on
unstable support. Keep good
footing and balance at all times.
10. Follow the maintenance instructions
specified in the manual.
risk of injection or
severe injury.
Keep clear of nozzle. do not discharge
streams at persons. This product is to be
used only by trained operators. Always
remove lance from gun before cleaning
debris from tip.
• Keep clear of nozzle. NEVER direct
high pressure spray at a person,
animal, or yourself.
• Always wear safety glasses or
goggles and protective equipment
(hearing protection, gloves,
rubber boots, protective clothing)
when operating or performing
maintenance.
• Never put hand or fingers over the
spray tip while operating the unit.
• Never try to stop or deflect leaks
with any body part.
• Always engage the trigger safety
latch in the safe position when
spraying is stopped even if only for a
few moments.
• Always follow detergent
manufacturer's label
recommendations for proper use
of detergents. Always protect eyes,
skin, and respiratory system from
detergent use.
do not use
pressure that
exceeds the operating pressure of
any of the parts (hoses, fittings, etc.)
in the pressurized system. ensure all
equipment and accessories are rated
to withstand the maximum working
pressure of the unit.
explosion
hazard.
3
• NEVER spray flammable liquids
or use pressure washer in areas
containing combustible dust, liquids,
or vapors.
• Never operate this machine in a
closed building or in or near an
explosive environment.
• Do not remove fuel tank cap or
fill fuel tank while engine is hot or
running (allow engine to cool two
minutes before refueling). Always
fill the tank slowly.
• Never disconnect the high pressure
discharge hose from the machine
while the system is pressurized. To
depressurize machine, turn power
and water supply off, then press the
gun trigger 2-3 times.
• Never permanently engage the
trigger mechanism on the gun.
• Never operate the machine without
all components properly connected
to the machine (handle, gun/wand
assembly, nozzle, etc.).
equipment
damage.
• ALWAYS turn water supply "ON"
before turning pressure washer
"ON." Running pump dry causes
serious damage.
• Do not operate the pressure washer
with the inlet water screen removed.
Keep screen clear of debris and
sediment.
• NEVER operate pressure washer
with broken or missing parts. Check
equipment regularly and repair or
replace worn or damaged parts
immediately.
• Use only the nozzle supplied with
this machine.
• Never leave the wand unattended
while the machine is running.
• Never tamper with the engine
governor or attempt to alter factory
settings. Altering factory settings
could damage the unit and will void
the warranty.
www.chpower.com
PW2575