Engine Oil Changing Instructions; Maintenance - Campbell Hausfeld PW2575 Manual Del Producto

operation (Continued)
4. Release the trigger prior to
switching the lance between high
and low pressure. Failure to do so
may reduce the life of the o-rings in
the lance.

Maintenance

Observe regular maintenance intervals
to ensure maximum performance and
life from the pressure washer. Refer
to the schedule for recommended
maintenance. If you operate the
pressure washer in dusty conditions,
perform maintenance checks more
often.
eNGINe oIl CHaNGING
INStruCtIoNS
before tipping the
engine or
equipment to drain oil, drain fuel from
the fuel tank.
Note: Change oil while the engine is
cool.
1. Disconnect the spark plug wire from
the spark plug.
2. Locate and remove the engine oil
drain plug (See Figure 16).
Figure 16 - oil Drain location
9
3. Drain old oil.
4. Replace the drain plug and set the
unit upright.
5. Refill the unit with new oil of a
recommended type and quantity. Fill
the unit to the proper level shown
on the dipstick.
PuMP oIl CHaNGING INStruCtIoNS
Changing or refilling the oil in the
pump requires removal of the pump
from the engine and should not be
required unless oil has leaked out due
to worn or damaged oil seals in the
pump. If oil has leaked out of the pump,
bring the pressure washer to a certified
Campbell Hausfeld service center for
repair.
www.chpower.com
PW2575