Satco NUVO 65-062 Instrucciones De Instalación Y Servicio

INSTALLATION AND SERVICE INSTRUCTIONS
PRECAUTION:
THIS PRODUCT CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS, AND / OR OTHER
REPRODUCTIVE HARM. THOROUGHLY WASH HANDS AFTER INSTALLING, HANDLING, CLEANING OR OTHERWISE TOUCHING THIS PRODUCT.
Before starting installation or service, disconnect the power by turning off the circuit breaker. Turning the power off by using the light switch
is not suffi cient to prevent electrical shock. All work should be performed by a qualifi ed electrician.
IMPORTANT: This product must be installed in accordance with the applicable installation code by a person familiar with the construction
and operation of the product and the hazards involved.
INSTALLATION:
Direct mounting to recessed box (wall mounting):
1. Remove the front housing by unscrewing the two screws
from the front lens of the fi xture.
2. Remove the refl ector (A) by loosening the two screws (C).
Be careful to not touch the LED array.
3. Remove the conduit plug with a screwdriver.
Punch out the desired mounting holes in the housing.
4. Route the fi xture power leads through the conduit hole.
Splice the power leads to the branch circuit leads – black to black (hot),
white to white (neutral) and green to green (ground).
5. Push the splices into the electrical junction box.
Carefully route the wires so they are not pinched
when completing the following steps.
6. Fasten the rear housing to the junction box.
7. Replace the refl ector. Remove the protective cover
from the LED Module.
8. Reinstall the front housing.
9. For wet locations, caulk between rear gasket and mounting surface
to prevent water from entering the fi xture from behind.
NOTE: This fi xture accepts AC input voltage in the range 120V-277V. No additional tap wires are provided.
TROUBLE SHOOTING CHECKLIST: If the light does not work.
1. Check your power source.
2. Check electrical connections.
©Copyright 2015 Satco Products, Inc. 10/15
Model: 65-062
LED Entrance Light
Satco Products, Inc.,
Brentwood, NY 11717