Installation And Use - SafeWaze 019-11000 Manual Del Usuario

User Manual

Installation and Use

Step 1: Remove tripod from tripod storage/carrying bag.
Step 2: Tripod must be mounted on a stable level surface for each leg, when positioned over
opening with a Maximum Installation Diameter of 44 inches. Lift tripod to upright position. Press
locking pin above each leg in the tripod head and pull leg away from center point until locking pin
locks into place. Repeat with the ramaining legs. (See Image 1)
Image 1
Locking Pin
Step 3: Remove Locking Pins above foot of tripod legs and extend legs to desired height. Re-insert
locking pin at desired height, (See Image 2) and connect safety chains to bottom of tripod legs.
Remove excess slack in the safety chain by adjusting the position of the twist link.
Image 2
Locking Pin
Step 4: This step decribes actions to be taken if attaching / installing a Safewaze 3-Way Retractable,
Material Winch, or Personnel Winch onto the tripod via mounting to one of the tripod legs. This step
must be performed in order to ensure proper routing of component cables through the top of the
tripod. Remove Cotter Pins, Pulley Housing, and pulleys from the top of tripod. (See Image 3 & 4)
Top of Tripod
Cotter Pin
Pulley Housing
(With pulleys removed)
Image 3
Image 4
Pulley
Page 8
V1.0 2020 Copyright SafeWaze