Safety Information - SafeWaze 019-11000 Manual Del Usuario

Safety Information

Failure to understand and comply with safety regulations may result in serious
injury or death. Regulations included herein are not all-inclusive, are for
reference only, and are not intended to replace a Competent Person's
WARNING
judgement or knowledge of federal or state standards.
Do not alter or misuse equipment.
Workplace conditions, including, but not limited to, flame, corrosive chemicals, electrical shock, sharp
objects, machinery, abrasive substances, weather conditions, and uneven surfaces, must be
assessed by a Competent Person before fall protection equipment is selected.
The inspection of the workplace must anticipate where workers will be performing their duties, the
routes they will take to reach their work, and the potential and existing fall hazards they may be
exposed to. Fall protection equipment must be chosen by a Competent Person. Selections must
account for all potential hazardous workplace conditions. All fall protection equipment should be
purchased in new and unused condition.
Fall protection systems must be selected and installed under the supervision of a Competent Person,
and used in a compliant manner. Fall protection systems must be designed in a manner compliant
with all federal, state, and safety regulations. Forces applied to anchors must be calculated by a
Competent Person.
Harnesses and connectors selected must be compliant with manufacturer's instructions, and must be
of compatible size and configuration. Snap hooks, carabiners, and other connectors must be
selected and applied in a compatible fashion. All risk of disengagement must be eliminated. All snap
hooks and carabiners must be self-locking and self-closing, and must never be connected to each
other.
A pre-planned rescue procedure is required in the event a fall occurs. The rescue plan must be
project-specific. The rescue plan must allow for employees to rescue themselves, or provide an
alternative means for their prompt rescue. Store rescue equipment in an easily accessible and clearly
marked area.
Training of Authorized Persons to correctly erect, inspect, disassemble, maintain, store, and use
equipment must be provided by a Competent Person. Training must include the ability to recognize
fall hazards, minimize the likelihood of fall hazards, and the correct use of personal fall arrest
systems.
NEVER use fall protection equipment of any kind to hang, lift, support, or hoist tools or equipment,
unless explicitly certified for such use.
Equipment subjected to forces of fall arrest must immediately be removed from use.
V1.0 2020 Copyright SafeWaze
User Manual
Page 12