Fitting The Hood - De Dietrich HOTTE Guía De Utilización

Energy saving advice
To obtain the best performance from your
appliance, limit the number of bends and
length of the duct as much as possible.
2.3 - FITTING THE HOOD
It takes 2 people to fit and fasten the
hood.
Do not remove the cables before the
hood is fully installed.
The minimum distance between the coo-
king surface and the lowest part of the
hood is 65cm. If the instructions for a hob
installed below the hood specify a dis-
tance greater than 65 cm, then that dis-
tance must be applied.
2.3.1 Fitting the ceiling support
- Using a plumb line, identify the centre of
the hob in relation to the ceiling support.
- The notch of the ceiling support (A) must
be facing the product.
- Fix the ceiling support with the 4 screws
and plugs provided (D/E).
2.3.2 Evacuation mode
- If your hob is in recycling mode, fix the de-
flector to the ceiling support with the 2
screws provided (M).
- Connect the duct to the deflector (recycle
mode), or inside an external duct on the
ceiling (evacuation mode).
2.3.3 Installing the duct support
- Once the duct support (C) has been cor-
rectly slotted in, insert the 4 screws (N) to
support the hood.
- Connect the duct to the deflector (recycle
mode), or inside an external duct on the
ceiling (evacuation mode).
2.3.4 Adapter
- For a 125 mm diameter duct, use the
adapter supplied (F).
- Slot the end of the duct onto the engine
output (recycle mode) or the check valve
(evacuation mode).
2.3.5 Installing / Fitting the body of the
hood
- Position your ducts on the product (H).
- Take the hood, now fitted with the ducts
- Place it under the duct support
- Press the upper part (B) to insert the hood
into the duct support
- The hood is held in place from the first
notch(1st click).
- You can now adjust the height of your ap-
pliance, by pushing it towards the ceiling
(at least 65 cm above your hob).
2.3.6 Clamping the duct
- At the required height, clamp the product
in place with the 4 screws provided
(N).
2.3.7 Fastening the duct
- Lift up the internal duct and screw the 4
screws (M) onto the ceiling support.
19