AERMEC FCLMC10 Manual Del Usuario página 5

FCLMC10
Fig. 1
Fig. 2
Fig. 3
Assembly of the kit
.
Join the two semi-cases using 6 self-threading screws
(supplied). (fig.1).
.
Apply the 4 reinforcement brackets at the congiuzioni of
the two semi cloaks using 4 screws (supplied for each)
mounting bracket. (fig.1).
.
The installation brackets are supplied already fitted to the
seed coats
Installation of the accessory
.
The FCL-FCLI cassette unit must be already installed (see
use and installation manual) (fig.3).
.
Make all hydraulic, electric and condensate
drain connections. The electric and hydraulic connec
tions must arrive from above and must not interfere with
the case.
.
Apply the FCLMC10 accessory to the cassette unit.
Align the holes of the two case brackets with
the holes in the cassette bracket, fixing them using the 4
screws (supplied) (fig.4).
.
Continue with installation of the grid unit
(GLL/GLLI) like in the normal procedure indicated in the
manual.
!
The FCLMC10 accessory is compatible with all grid units for
module 600.
Maintenance.
To clean the case and the visible part of the fan coil, use soft
cloths or sponges dampened in water at maximum temperature
of 40°C. Do not use chemical products or solvents on any part of
the fan coil. Do not spray water on interior or exterior surfaces of
the fan coil (danger of short circuits).
FCLMC10_ 6204300_01
5