Section 3: Assembly
2.
Insert carriage boks through
holes from outside of unit
and attach a phstic knob from insNe of unit (Figure 2).
Tighten by hand.
%
3.
Phce accessory tray over holes on hande (viewing
from front of uniO. Pushthe tree clips into the holes
until they sit fiat against the accessory tray (Figure 3).
/
4.
Insert"L"
hook through hole just above billboard on
left side of handle (viewing from front of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 4).Tighten
by hand.
Spray Gun Hook
5.
Insert multi-colored
ProjectPro TMnozzles and other
supplied accessories in spaces provided in accessory
tray, See "How to Use AccessoryTray'.
Add
Engine
Oil
and
Fuel
° Place pressure washer on a [eve[ surface,
Refer to engine manual for oil and fuel fill information.
- Damage to equipment resuking from failure to follow this
instruction will void warranty.
" Refer to engine owner's manual and follow oil and fuel
recommendations
and instructions,
NOTE:
Check oil often during engine break-in,
Refer to
engine owner's manual for recommendations,
O