Add Engine Oil And Fuel; Connect Hose And Water Supply To Pump - Troy-Bilt 020210 Manual Del Propietário

Section 3: Assembly
Attach Handle
I. Placehandte assemblyonto handle supports connected
to main unit. Make sure holes in handle align with hotes
on handle supports (Figure 2).
Alig
Handle
Supports
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it witi slide
over the handle supports.
2. Insert carriage bolts through holes from outside of unit
and attach plastic knob on inside of handles (Figure 3).
Tighten by hand.
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
CAUTION
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instructionwill void warranty.
• Refer to engine owner's manual and follow oit and fuel
recommendations and instructions.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manualfor recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, y ou must assemble
the nozzle extension to the spray gun and attach alt hoses
before you start the engine.
I. Uncoil high pressure hose and attach quick connect
end of hose to base of spray gun (Figure 4). Putl down
on collar of quick connect, slide onto spray gun and let
go of collar.Tug on hose to be sure of tight connection.
3.
Insert multi-colored spray tips in spaces provided in
handle.
Connect high
pressurehose
._ here.
\
NOTE: Remove and discard all pump shipping caps before
attaching hoses.