Add Engine Oil And Fuel - Troy-Bilt 020245 Instrucciones De Uso

Section 3: Assembly
2. Insert carriage boks through holes from outside of unit
and attach a phstic knob from insNe of unit (Figure 2).
Tighten by hand.
4. Insert"L" hook through hole just above billboard on
left side of handle (viewing from front of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 4),Tighten by hand.
Spray Gun Hook
Place accessory tray over holes on handle (viewing
from front of unit). Push the tree clips into the holes
until they sit fiat against the accessory tray (Figure 3).
5. Insert muki-colored ProjectPro TMnozzles and other
supplied accessories in spaces provided in accessory
tray, See "How to Use AccessoryTray'.
Add Engine Oil and Fuel
° Place pressure washer on a [eve[ surface,
Refer to engine manual for oil and fuel fill information.
- Damage to equipment resulting from failure to follow this
instruction will void warranty.
" Refer to engine owner's manual and follow oil and fuel
recommendations and instructions,
NOTE: Check oil often during engine break-in, Refer to
engine owner's manual for recommendations,
O