Add Engine Oil And Fuel - Troy-Bilt 01905 Manual Del Propietário

Section 3: Assembly
Install Oil Dipstick on Pump
To install the oil dipstick:
I. Make sure unit is on a level surface.
CAUTION
• Failure to do so will void the warranty and damage the
pump.
2. Remove and discard shipping cap located on pump
(Figure 3).
Remove shipping cap and
instaltoil dipstick here.
Shipping Cap
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
CAUTION
• Refer to engine manualfor oil andfuel fill information.
• Damage to equipment resulting from failure to follow this
instructionwill void warranty.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
(
Pump Oit
Dipstick
3. Install oil dipstick.