Temperature - Warm-Up (K-558) - Kohler K-527 Guía De Propietario

Enable default outlet (y),
all outlets (A), or disable (n).
Temperature – Warm-up (K-558)
Program 10: When enabled, the shower will turn on and water will
flow until the set temperature (default) is reached.
The factory default is warm-up mode disabled (n).
NOTE: The displayed temperature is the set temperature. The
displayed temperature will blink until the actual temperature
reaches the set temperature.
NOTE: All outlets must be enabled (Prog 8) for all outlets (A) to
appear. See the "Water – Set Active Outlets" section.
Once the set temperature is reached the shower will automatically
pause until the user presses the [Power] icon to resume showering. If
the shower is not resumed within 2 minutes, the system will
automatically turn off.
Choose "Prog 10" from the settings menu.
Use the [Up] or [Down] icon to choose "y" to enable warm-up
mode for the default outlet, "A" for all outlets, or "n" to disable.
Press the [Power] icon to set.
Press the [Power] icon again to return to the settings menu.
Refer to the "Settings Menu" section to access other settings or
exit the menu.
1214635-5-B 20 Kohler Co.