Clean The Inlet Screens - Kohler K-527 Guía De Propietario

Check Valve
Copper
Tube
Nut
Seal

Clean the Inlet Screens

Disconnect the power and turn off the water supply.
Unthread the plastic nuts from the hot and cold inlets.
Remove the copper tubes. The O-ring and screen may be attached
to the end of the tube.
If the screen remains in the check valve, use a small flat-blade
screwdriver to gently pull the check valve from the valve inlets.
Remove the screens from the copper tubes or check valves.
Clean the screens to remove any dirt or debris.
Rinse or replace the check valves and screens.
Reassemble the inlet connections.
1214635-5-B
Screen
O-Ring
30 Kohler Co.