Cleaning And Maintenance - Haverland IDK-1 Manual De Instrucciones

1. Place the heater on a flat level surface and ensure that the air intake and air outlet are clear of
obstructions.
2. Insert the plug into a 230 V~ 50 Hz power outlet.
3. Move the ON/OFF SWITCH at the rear of the unit to the on (I) position.
4. Press the button on the control panel to turn the heater on.
5. Press the button to adjust the work mode and the mode indicator on the display screen will be
on accordingly. It will memorize the setting you use before you turn off the unit last time.
IDK has 4 working modes:
a. ECO Mode: the unit will work under 1400-1600 W ; choose this mode when the unit is to be
used for a long period of time.
b. Quick Heating Mode: the unit will work under 1800-2100 W so the unit will heat the space very
quick, choose this mode when the unit is used to heat large spaces or there are many people in the
room.
c. Child Mode: the unit will work under 900-1100 W offering a not so hot temperature; choose this
mode when children and/or babies are present in the room.
d. Sleep Mode: the unit will work under 1100-1300 W; choose this mode when the unit is used for
sleeping. This mode is very quiet.
You can set the temperature 4-32 degree C. The unit will stop heating if the room temperature is 2
degrees higher than setting temperature, and it will keep working if the room temperature is lower
than setting temperature.
6. Press the button to set up the timer hours.
7. Press button again to turn off the unit and the fan will keep working for around 25 seconds to
cool down the heating element.
8. Move the ON/OFF SWITCH at the rear of the unit to the off position (O) after the fan stops working.
Turn the power off and disconnect the plug from the power outlet when not in use.
Note: For Child Lock function, you could press the
press button for 5 seconds to lock and unlock the unit.
• Ensure that the heater is turned off (the switch on the back of the unit should be in the off position),
Unplug the power cord from the wall outlet before cleaning.
• If you do not use the device for a long time, clean it and put it in a box. Store in a dry, ventilated
place.
• To clean the appliance, wait until it is completely cold and disconnect it from the mains socket.
• Use a damp cloth to clean the unit. Never clean it by splashing it with water or inserting it into the
appliance. The dust accumulated on the front vent of the appliance can be removed with a damp
cloth or using a vacuum cleaner with brush attachment.
• Never clean the appliance with acids, gasoline, benzene, etc.
• Before using the appliance again, check it and make sure that nothing obstructs the air inlets and
outlets.
OPERATION

CLEANING AND MAINTENANCE

4
button on the remote control or you can