Mowox RM 600 Li BT Instrucciones De Funcionamiento Originales página 82

• Step 2: Open the cover of the battery box, take the battery off, and insert the USB
flash device into the USB port shown as below.
• Step 3: Insert the battery again, turn the main power switch to "ON".
Press and
Press to start updating. Once the update is finished, the robotic mower restarts and
the screen enters the "Input PIN" page. This means the firmware is updated
successfully.
Make sure the battery level is enough for updating (>50% left).
Don't press the main power switch during updating.
Rev 7
together for 4 seconds to enter the Boot Mode.
Boot Mode
1-Generate PUK
2-Update firmware
(wireless)
3-Update firmware
(U-disk)
4-Restart
35 (EN)
Updating Firmware
Waiting
59%