Switch Positions - SEVERIN WL 0807 Instrucciones De Uso

down, it may be switched on again.
 Before the appliance is used, the main body
as well as any attachment fi tted should be
checked thoroughly for any defects. Should
the appliance, for instance, have been
dropped onto a hard surface, it must not
be used any longer: even invisible damage
may have adverse effects on the operational
safety of the appliance.
 Do not leave the appliance unattended
while in use.
 To prevent damage to the power cord,
- do not bend or kink the cable, especially
where it leaves the housing,
- do not pull on the cord,
- do not coil the power cord around the
appliance.
 Do not place the appliance on any surface
sensitive to heat during or immediately after
use.
 Do not operate the appliance if it is stored
on the hanging loop.
 Make sure that the hot round brush is kept
well away from the scalp.
 When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
 Always switch off and remove the
plug from the wall socket
- after use, as well as
- in cases of malfunction, and
- during cleaning.
 No responsibility will be accepted if damage
results from improper use, or if these
instructions are not complied with.
 This appliance is intended for domestic or
similar applications, such as in
- shops, offi ces and other similar working
environments,
- agricultural areas,
- hotels, motels etc. and similar
establishments,
- bed and breakfast type environments.
 In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualifi ed
personnel, including the replacement of the
power cord. If repairs are needed, please
send the appliance to one of our customer
service departments. The address can be
found in the appendix to this manual.
Operation
Changing the round brush
The round brushes can be changed by simply
pulling the brush off and sliding the other
one on.
Caution: Do not press the curl release button
while changing a brush.

Switch positions

The appliance is equipped with a 4-position
switch allowing for various settings:
Functions:
0 = Off
I = Half power
II = Full power
❄ = Cool-shot setting (cooling down)
Use
– The round brush is designed for shaping
the hair. To achieve this, the hair should be
divided into single strands (not too thick) and
then spread evenly over the brush, turning
them inwards or outwards as desired.
– Apply for a few seconds at a time only,
while letting the hot air take effect on the
hair.
– To fi x a particular strand of hair, use the
cool-setting for a few seconds afterwards.
– Press the curl release button
brush out of the strands of hair.
– Let the hair cool down suffi ciently before
brushing it out.
General cleaning and care
 Before cleaning the appliance, ensure it is
disconnected from the power supply and
has cooled down completely.
 To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
10
to roll the