Kobalt KAG 424B-03 Manual De Instrucciones página 15

OPERATING INSTRUCTIONS
7. Using with Grinding Wheels
CAUTION:
• To reduce the risk of injury, read all safety
warnings and all instructions in the use, care and
protection of wheels.
• Always wear safety goggles or safety glasses
with side shields during power tool operation. If
the operation is dusty, also wear a dust mask.
• A grinding guard must be installed when using a
grinding wheel to provide maximum protection for
the operator.
Check the grinding wheels before application.
Discard wheels that have been dropped, bumped, subjected to extreme changes in
temperature, or have come into contact with solvents or liquids.
a. Before beginning a period of work, test the tool by letting it spin for one minute before
applying it to the workpiece.
b. Make sure that the workpiece is firmly clamped in place.
c. Hold the tool securely with both hands.
d. Start the tool.
NOTICE: If the battery is inserted when the tool switch is in the "ON" position, the tool will not
run. Turn the tool off, then back on to begin work.
e. Allow the accessory to reach full speed before beginning work.
f. For a uniform finish, hold the tool at an angle of approximately 10° to 15° and apply
constant pressure. Too great an angle causes concentrated pressure on small areas,
which may gouge or burn the work surface.
g. Control the pressure and surface contact between accessory and workpiece.
WARNING
• Do not apply too much pressure. Too much pressure will cause the tool to overload and may
cause personal injury.
h. When finished, turn off the tool and make sure that it comes to a complete stop before
laying it down.
7
15
10° to 15°