Auxiliary Handle - Kobalt KAG 424B-03 Manual De Instrucciones

OPERATING INSTRUCTIONS

4. Auxiliary Handle

This angle grinder/cut-off tool is equipped with an
auxiliary handle (H). The handle can be installed
in any of three auxiliary-handle sockets (D). For
ease of operation, position the auxiliary handle in
the location that offers the best control and guard
protection.
a. To install the auxiliary handle, remove the
battery pack, then thread the auxiliary handle
into the auxiliary-handle socket and tighten the
handle securely by turning it clockwise.
b. To remove the auxiliary handle, remove the
battery pack, then loosen the auxiliary handle
by turning the handle counterclockwise.
WARNING
• For safety and ease of operation, securely tighten the auxiliary handle by turning the handle
clockwise before every use.
• To reduce the risk of injury, always remove battery pack before making any adjustments or
accessory changing.
5. Guard
This tool is shipped with two guards (L,J). A guard
must be used when using the tool as a grinder or
cut- off tool.
To Install the Guard
a. Remove the battery pack and remove any
accessory from the spindle.
b. Open the guard lever to release the guard.
c. Align the tabs on the guard with the slots in the
grinder gear-case hub and place the guard on
the gear box, lowering it until the guard can
rotate freely in the groove on the gear case hub.
d. Rotate the guard to a suitable position so that the
guard body is positioned between the spindle and
the operator to provide maximum operator protection.
e. Tighten the guard by pulling the guard lever.
NOTICE: Use only specified size grinding wheels with the grinding guard. Use only specified
size cut-off wheels with the cutting guard.
NOTICE: The guard is pre-adjusted to the diameter of the gear-case hub at the factory. If,
after a period of time, the guard becomes loose, tighten the adjusting screw in the guard with a
Phillips screwdriver (not included).
CAUTION:
• If guard cannot be tightened by adjusting the screw, do not use the tool and take the tool
and guard to a service center to repair or replace the guard.
4
5a
Guard lever
12
D H
L