Assembly And Operation - Worx WX543L Manual Del Usuario

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly on
the workpiece. It is suitable for straight and curved
cuts. The saw blade recommendations are to be
observed.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
Blade Installation
Note: Ensure the blade is installed
in place. The black line on the blade
10
needs to be totally inserted into the
tool-free blade holder.
Blade Removal
Note: Hold the blade with one hand
when remove the blade.
Vacuum Adapter Installation
Vacuum Adapter Removal
Note: Press and hold the projection
on the bottom of the vacuum
adapter before pulling it out of the
machine.
OPERATION
Pendulum Function
Safety On/Off Switch
Note: For safety reasons the On/
Off switch of the machine cannot
be locked; it must remain pressed
during the entire operation.
Increasing or reducing the pressure
on the On/Off switch enables stroke-
rate control of the switched-on
machine.
Cordless Jigsaw
Straight Cut and Curve Cut
Bevel Cut
Note: Remove the vacuum adapter
before adjusting the base plate.
Note: Rotate the base plate to the
desired position according to the
scale. Ensure the blade is engaged
between the blade positioning
wheel.
Plunge Cut
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B1
See Fig. B2
See Fig. B3
See Fig. B4
See Fig. C
See Fig. D
See Fig.
E1, E2
See Fig.
F , G
See Fig. H
EN