HoMedics BPA-065 Manual Del Usuario página 16

1. If the cuff is not assembled, pass the end of the cuff furthest
away from the tubing through the metal D-ring in order to form
a loop. The smooth side without the felt material should be on
the inside of the cuff loop.
2. Plug the cuff tube into the left side of the unit.
3. Open the arm cuff so that your arm may be placed through it.
4. Remove tight fitting clothing from your upper left arm so that
the cuff can be wrapped around your exposed arm.
5. Position cuff edge 0.8-1.2
inches (2-3 cm) above elbow.
End of cuff
D-ring
Insert plug
15