Astralpool Aquasphere VSN Serie Manual De Instrucciones página 25

P3 Water pump
P4 Current time
P5 Timer on
P6 Timer off
P7 Water temp.
calibration
NOTE: Under defrosting mode, P0=1. After defrosting finished, it will be automatic enter Normal mode,
P0=0.
6.1.4 System reset function
Press and
6.1.5
Symbol of heating, the light will be on when it is in operation.
When defrosting, the light will flash.
6.1.6
Symbol of cooling, the light will be on when it is in operation.
Note: When parameter P1 is on checking/adjusting,
6.1.7
Symbol of automatic stop, the light will be on when it is in operation.
6.1.8
Symbol of automatic start, the light will be on when it is in operation.
6.1.9
Press this button, the light will be flash, the heat pump will operate in 'Full output' only.
6.1.10
While you choose the Smart, the heat pump will just operate in 'Medium output' and 'Full output'
0-1
HH:MM
HH:MM
HH:MM
-9～9
in 10s, the system will reset and display "0000" on the controller.
1:Always running;
0
0:Depends on the running of compressor
0-23:0-59
00：00
0-23:0-59
00：00
0-23:0-59
00：00
0 Default setting: 0
and
21
will be flashing at the same time.