General Setup - Grundfos DID Instrucciones De Instalación Y Funcionamiento

9.3.5 Alarm screen
AP001 A1/1
2020/Sep/05
pH below
lower alarm limit
AP001 A1/1 The amount of alarms and the number of the
selected alarm
2020/Sep/05
Date and time of occurrence of the alarm
(YYYY/MMM/DD HH:NN:SS)
16:40:21
pH below
The alarm message
lower alarm limit
An alarm can be acknowledged with [OK]. If the reason of the
alarm is still present, a new alarm will be generated immediately.
9.3.6 USB screen
The USB menu is activated when a USB stick is plugged in the
USB slot.
USB data transfer
Copy results
►
Delete results
Copy log/cfg
Delete log/cfg
Update software
Copy license
Config backup
Config restore
14

9.4 General setup

In the "Setup" menu, general settings can be made.
• Press the [Function] button in the status screen to open the
"Setup" menu.
16:40:21
Setup
Manage sensors...
►
Cleaning 1...
Cleaning 2...
Meas. settings...
Date/Time...
MODBUS slave...
Setup
MODBUS slave...
►
Update software...
Select language...
Service...
License...
Submenu
Manage sensors...
Cleaning 1...
Cleaning 2...
Meas. settings...
Date/Time...
MODBUS slave...
Update software...
Select language...
Service...
License...
Settings
Add, remove, configure sensors or
parameters.
DID with immersed sensor and cleaning
device: Configure cleaning device.
Required for optical probes or if different
cleaning devices are used. Not required
for DID.
Set the measurement interval between 1-
3600 s.
Adjust date and time.
If CU 382 is used as MODBUS-Slave:
Change MODBUS settings.
Update the software of the control unit
via the USB port.
Choose the operating language.
Make additional settings and function
checks.
This menu is protected by a password
and should only be opened by an
authorised person.
Displays the features of the installed
license.