Braun Pulse oximeter 1 Manual De Instrucciones página 11

Errors and troubleshooting
Error message
SpO2 or PR can
not be shown
normally
SpO2 or PR
reading is
unsteady
The oximeter can
not be turned on
Unit turned off
Low battery
displayed
Situation
Finger is not fully
inserted into device
User's
oxyhemoglobin
value is too low to
be measured
Finger is not fully
inserted into device
User is moving or
finger is shaking
Inadequate power
or power off
Batteries are
installed incorrectly
The oximeter might
be damaged
The product
automatically shuts
off when no signal
can be detected
within 8 seconds
Inadequate power
Batteries need to be
replaced
English
Solution
Retry by correctly
inserting the finger
Try a few more times
If you can make
sure that there is
no problem in the
product, please go
to the hospital in a
timely manner for
exact diagnosis
Retry by correctly
inserting the finger
Remain as still as
possible
Replace the batteries
Please reinstall the
batteries
Please contact the
customer service
center
Normal
Replace the batteries
Replace the batteries
11