Parameter Set Up - Braun Pulse oximeter 1 Manual De Instrucciones

Parameter set up

Press the Power/Menu button to
turn on the device. With the device
turned on, press and hold the
Power/Menu button to change the
display mode.
Press and hold the Power/Menu
button (approx. > 3seconds) until you enter the parameter
setup menu 1 and hold down again (approx. 3 seconds)
to enter screen 2.
1. In menu 1 or 2 press the Power/Menu button to cycle
through the various parameters. You will see the
move to each parameter as you cycle through. When
you are at the parameter you wish to change, press
the Power/Menu button for 3 seconds to change the
parameter setting.
2. If you wish to restore to factory settings, move the
the restore selection on menu 1 and hold the Power/
Menu button down for approximately 3 seconds.
3. To exit the menus and return to the measurement
screen, move the
2 and hold the Power/Menu button for 3 seconds, or
simply wait 10-12 seconds without interacting with
device and it will return to the measurement screen.
Attention
If using device outdoors or under strong light, please
increase the screen brightness to improve legibility.
Choose a lower screen brightness to conserve
battery power.
* to the exit selection on menu 1 or
English
Sp0 PR
% bpm
2
-- ---
*
* to
9