Stanley Compulevel Guia Del Usuario página 15

47855 CompuLevel
3) Move the measurement module below to the desired elevation, half the
band.
4) Press the MARK key momentarily, while holding the unit steady, to set
the audible tone.
To use the MARK function: to create audible tones outside the
measurement band:
1) Place the measurement module at the desired elevation.
2) Press and hold the MARK key for two seconds. Hold the unit steady
until double band lines flash in the display window.
3) Move the measurement module above to the desired elevation, half the
band.
4) Press the MARK key momentarily, while holding the unit steady, to set
the audible tone.
Note: this procedure will create a solid audible tone above the
measurement band and a warbling tone below the measurement band.
There will be no tone within the band.
Notes: The fraction bar flashes in the display window to indicate that you
are in the MARK function.
To exit the MARK function and retain setting, momentarily press the
MARK and ON/OFF keys together.
Press the MARK key for two seconds to re-enter.
Tones can supplement display to level or alarm at height limits.
STEP 1
DISPLAY
TONES
TONE
AT
MARK
USE FOR PRECISE LEVELLING
TONE
INSIDE
OF
BAND
USE FOR PRECISE LEVELLING
TONE
OUTSDE
OF
BAND
BEST FOR ROUGH LEVELLING OR
ELEVATION LIMIT INDICATION
6/11/07 11:14
Enter at elevation
Double beep
Mark
Page 14
Set band
STEP 2
Single beep
Band
Compulevel TM Measurement system • 14
Tone
No tone
Tone
No tone
Steady
No tone
Beeping Tone