On/Off, Hold & Zero - Stanley Compulevel Guia Del Usuario

47855 CompuLevel
Mechanics of Use
Typical Handling
Manage cord with left hand, gently
'whip' over small objects.
For consistent readings,
balance with unipod
between middle fingers like
a plumb-bob before
contacting surface.
Easiest cord
removal
direction
Quick jerks may cause reel
over-spin and cord jams
Labelled Functions
The following section describes how to operate COMPULEVEL's labelled
functions. Glance through all the functions and the example illustrations
then try each function on your COMPULEVEL
ON/OFF
Momentarily press the ON/OFF key to turn COMPULEVEL
key is pressed, or the measurement module is not moved in four minutes,
the unit powers down automatically. The unit emits two long warning
beeps after three minutes of no movement or keypad activity to warn of
shut-off activity.
HOLD
The HOLD function is used to make and retain a measurement from any
location where the display is hard to see, such as overhead, in a deep
trench, or anytime you want to hold a measurement on the display while
moving the measurement module. The HOLD function is toggled on/off by
momentarily pressing the HOLD key.
6/11/07 11:14
Thumb can
reach the 3
most used
keys
Cord Removal
Docking area
Avoid pulling or winding
cord in docking area
Page 8
Suggested Reeling Technique
.
TM
TM on or off. If no
Compulevel TM Measurement system • 8
Rest 'round'
against thigh
Dock
measurement
module face-up
Slowly move from side
to side to make cord
uniform on reel