Intended Use; Assembly & Operation - Worx WG606 Manual Del Usuario

Protection class
ACCESSORIES
Nozzle (25° / 40° / soap )
Turbo Nozzle
25ft Hose
Declogging needle
We recommend that you purchase your accessories listed
in the above list from the same store that sold you the tool.
Refer to the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.

INTENDED USE

The electric high pressure washer is intended for residen-
tial cleaning projects-from porch to patio, driveways and
10
decks, boats, pavers, bricks, BBQs and more.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Lifting the telescoping handle
Attaching the lance
NOTE: when attaching, align the two
projections on the lance with the
grooves on the wand.
Attaching the wand holder
Screwing & Unscrewing the high pres-
sure hose
NOTE: Make sure the hose is tightly
connected.
NOTE: For convenience of unscrewing
the hose, please pull the trigger to drain
water from wand when operation is
completed and on/off switch is in "O"
position.
Electric Pressure Washer
Attaching the garden hose
/II
Connect one end of the home garden
hose (not supplied) to the adapter and
another end to waterspout.
OPERATION
Extension cord
WG606
It is not recommended to use the
extension cord. If necessary, ensure
3
the plug and extension cord con-
nection is on an elevated surface
1
that does not contact the water
area.
1
GFCI plug test
1
Press "test", the light will be out.
Press "reset", the power regains and the
light will illuminate.
NOTE: To keep good operation of
GFCI, please implement it once a
month.
Start/stop
Turn on the water supply tap. Connect
the washer to the power supply and
turn the on/off switch to "I " position.
Then press trigger.
NOTE: Before pressing trigger, push
the lock-out down into the trigger.
and turning on the water supply
because it may cause damage to
high pressure seals and reduce the
service life of pump.
Release the trigger and turn the on/
FIGURE
off switch to "O" position. Turn Off the
water supply tap.
NOTE: When not in use, push the
lock-out up until it clicks into the
See Fig. A
slot.
See Fig. B1,
Select the right nozzles
B2
Select the suitable nozzle for different
cleaning jobs.
Nozzle 25
See Fig. C1,
cleaning on concrete, bricks and
C2
masonry.
Nozzle 40
See Fig. D1,
cleaning on wooden and other soft
D2, D3, D4
objects.
The soap nozzle is applicable for soap-
ing while other nozzles cannot be used
to do it.
Turbo nozzle is applicable for cleaning
on concrete, bricks and masonry.
powered on.
WARNING: Do not start the
machine without connecting
(green) is applicable for
0
(white) is applicable for
O
WARNING: Do not change the
nozzle pattern when the tool is
See Fig. E
See Fig. F
See Fig. G
See Fig. H1,
H2
See Fig. I1, I2
See Fig. J
EN