Switching Off; Temperature Regulation; High Temperature Alarm; Frostmatic Function - AEG AGE62526NW Manual De Instrucciones

20 www.aeg.com
It is possible to change the predefined
sound of buttons by pressing together
Display
A. Timer function
B. FROSTMATIC function
C. Temperature indicator
D. Alarm indicator
4.2 Switching on
1. Connect the mains plug to the power
socket.
2. Press the appliance ON/OFF if the
display is off.
The alarm buzzer could operate after few
seconds.
The temperature indicators show the set
default temperature.
To reset the alarm refer to "High
temperature alarm".
To select a different set temperature
refer to "Temperature regulation".
If "dEMo" appears on the display, refer
to "Troubleshooting" chapter.

4.3 Switching off

1. Press ON/OFF for a few seconds.
The display switches off.
2. Disconnect the mains plug from the
power socket.

4.4 Temperature regulation

The set temperature of the freezer may
be adjusted by pressing the temperature
button.
Default temperature:
• -18°C for the freezer
The temperature indicator shows the set
temperature.
The set temperature will be
reached within 24 hours.
After a power failure the set
temperature remains stored.
Mode and Temperature colder button
for some seconds. Change is reversible.
A B
F E D
E. ChildLock function
F. DrinksChill function

4.5 High temperature alarm

An increase in the temperature in the
freezer compartment (for example due to
an earlier power failure) is indicated by:
• flashing of the alarm and freezer
temperature indicators;
• sounding of the buzzer.
Press any button to reset the alarm.
The buzzer switches off.
The freezer temperature indicator shows
the highest temperature reached for a
few seconds. Then show again the set
temperature.
The alarm indicator continues to flash
until the normal conditions are restored.

4.6 FROSTMATIC function

This function accelerates the freezing of
fresh food and protects food products
already stored from warming.
1. Press Mode button repeatedly until
2. Press OK button to confirm your
The FROSTMATIC indicator is displayed.
C
FROSTMATIC icon flashes.
selection.
This function deactivates
automatically after 52 hours.
To switch off the function
before its automatic end,
repeat the steps until the
FROSTMATIC indicator
disappears.