AEG AGE62526NW Manual De Instrucciones página 23

7.1 What to do if...
Problem
The appliance is noisy.
Audible or visual alarm is
on.
A square symbol is shown
instead of numbers on the
temperature display.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FROSTMATIC
or after changing the tem-
perature.
Water flows on the floor.
Possible cause
The appliance is not sup-
ported properly.
The cabinet has been re-
cently switched on or the
temperature is still too
high.
The temperature in the ap-
pliance is too high.
Temperature sensor prob-
lem.
The lamp is in stand-by
mode.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FROSTMATIC function
is switched on.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
ENGLISH
Solution
Check if the appliance stands
stable.
Refer to "Door Open Alarm/
Indicator" or "High Tempera-
ture Alarm/Indicator".
Refer to "Door Open Alarm/
Indicator" or "High Tempera-
ture Alarm/Indicator".
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation"/"Control
Panel" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "FROSTMATIC func-
tion".
The compressor starts after
some time.
Attach the melting water out-
let to the evaporative tray.
23