Brushless Electrical Micromotor - Built In (Optional) - Olsen Logic Plus Guía De Operación

The selected direction is shown on the display (3).
To adjust the micromotor water: use the water control knob (15)
on the instruments control panel.
To access setup menu: press and hold the Setting key (12).
Use the Setting key (12) to select the desired option.
To adjust LED options: use the adjustment keys (13) to set the
parameter.
LED Off
To adjust pneumatic activation method: use the adjustment keys (13) to set the parameter. The selected
pneumatic activation method is shown on the display (6).
Micromotor performs speed according to
the pressure on the pedal (14)
To adjust input pneumatic pressure: use the adjustment keys (13) to set the parameter.
Set minimum activation pressure
from 0.03 to 0.10 MPa
Note: the micromotor system preset by the factory according to the internal equipment pressure. It is not
recommended to change the pressure parameters.

6.8.4 - Brushless Electrical Micromotor - Built in (Optional)

Before starting the operation,
connect the handpiece to the electrical
micromotor (8).
To activate
propulsion/activation pedal (7).
To select the transmission: use the Select key (5). The
selection is indicated by LED's (3): 20: 1; 1: 1 and 1: 5.
To reverse the rotation: use the Reverse key (1).
To adjust speed: use the adjustment key (4) The speed relation of each transmission with the value of the
display (2) is indicated in the side table.
The selected speed is shown on the display (5).
To select the gear ratio: use Gear Ratio key (10). There are the
following values available: 1:5, 1:1, 4:1, 10:1, 16:1 and 20:1.
The selected gear ratio is shown on the display (4).
To change the rotation direction: use the Direction key (9).
LED On
without delay
the rotation: press
Reverse
LED On
with 10s delay
When pedal (14) is pressed micromotor
performs the maximum speed adjusted
Set maximum input pressure
from 0.20 to 0.40 MPa
the
18
Forward