Multi-Articulated Headrest; Swivel Armrest; Instruments Operation; Pneumatic Handpiece Couplings - Olsen Logic Plus Guía De Operación

5.8.4 - Multi-articulated Headrest

To adjust the headrest position: turn the knob (1) counterclockwise, adjust
the headrest (2) in the desired position. Turn the knob (1) clockwise to lock the
headrest in the set position.
To adjust the height of the headrest: move the bar (3) until you reach the
position. The headrest bar allows adjustment with up to 15 cm from the backrest.

5.8.5 - Swivel Armrest

To move the swivel armrest: press the trigger (1) and push the armrest down.

- Pneumatic Handpiece Couplings

Before starting the operation connect the handpiece (1) to
the coupling by attaching it to the coupling ring (2), ensuring that it
is properly connected and that there is no leakage of air or water.
To activate the rotation: press the propulsion/activation
pedal (5). The higher the pressure applied to the pedal, the more
speed in the handpiece, until reaching the pressure limits of the
equipment.
To adjust the spray: turn the adjusting ring (4) until the desired volume of water. To
adjust the maximum flow of water, bring the spray adjustment indicators (3) closer to each
other. To decrease the flow of water, rotate the ring so it distances one indicator from the
other. The completely opposite points indicate the minimum water regulation for the spray.

- Optical Fiber Handpiece (Optional)

Before starting the operation connect the optical fiber
handpiece to the coupling by attaching it to the coupling
ring (1), ensuring that it is properly connected and there is
no leakage of air or water.
To activate
propulsion/activation pedal (2). The higher the pressure
applied to the pedal, the more speed in the handpiece, until
reaching the pressure limits of the equipment.
To turn the coupling's light On/Off: use the On/Off
optical fiber light (3) on the command panel (section 5.4) of
the working table.
To adjust the spray: use the optical fiber water control
knob (4) on the instruments control panel (section 5.4).

- Venturi Saliva Ejector

Before starting the operation with the Venturi saliva ejector (2), insert the cannula
into the 6,3 or 9,5 mm adapter (3).
To activate the suction: remove the ejector (2) from the holder (1).
To deactivate the suction: place the ejector in its holder (1).
The cannula adapter (3) is removable for cleaning.

6 - Instruments Operation

the rotation: press the
14