Garland ROLL&COMB 302EUS-V21 Manual De Instrucciones página 4

English
• Always have your hands warm.
• Take frequent breaks.
• Always hold the machine tightly by the
handles.
If you detect any of the symptoms of the white
finger syndrome, consult immediately with your
doctor.
2.3. WORKING AREA SECURITY
Maintain the working area clean and work with
good light. Untidy working areas and dark
conditions can cause accidents.
Inspect the working area and remove all stones,
wood, cables and strange objects that could be
touched and propelled by the moving parts of
the machine.
Do not use the machine in explosive
atmospheres or in the presence of inflammable
liquids, gases and powders. Electric machines
can release sparks that could ignite the
inflammable liquids, gases and powders.
Maintain children, other people and animals well
clear of the machine whilst working. Distractions
can cause the loss of control. Be vigilant and
stop any children, other people and animals
coming into the working area.
Do not use this machine at night, with fog or
with reduced visibility that does not allow you to
see the working area.
2.4. ELECTRICAL SECURITY
The electrical switch of this machine must
coincide with the mains switch. Do not modify
the switch in any way. If no parts have been
modified and they fit perfectly, there will be no
electric shock accidents.
Avoid body contact with earthed surfaces such
as tubes, radiators, electric kitchens and
refrigerators. There is a higher electric shock
possibility if your body is earthed.
Don't expose this machine to rain, wet
or humid conditions. If water enters the
machine there will be a higher risk of
electric shock.
Do not overstretch the cable. Do not use the
cable to transport the machine, lift the machine
and to unplug the machine. Maintain the cable
far away from heat sources, oil, sharp edges or
other moving parts. Damaged or tangled cables
increase the risk of electric shock.
Never use this machine if the cable or the plug
are damaged. Before connecting the machine
check that the cable and the plug are not
damaged. If you discover that either of these
elements are damaged, take your machine to
your nearest after sales dealer. Should the cable
be damaged, unplug the machine immediately.
Damaged or tangled cables increase the risk of
electric shock.
The substitution of the plug or cable should
be done by an approved and approved after
sales service. We recommend that this machine
should be connected to residual differential
whose current is lower or equal to 30mA.
Never use a connecting base that is damaged or
that does not comply with current standards or
with the requisites established for this machine
in this manual.
When using a cable extension, make sure that
its minimum section is AWG16 or 1.5mm
no longer than 15 meters, always unrolled and
adequate for outdoor use. The use of the cable
extension adequate for outdoor use, reduces
the risk of electric shock.
Place the cable extension in such a way that
it will not get caught in branches or other
obstacles and in such a way that it is not in the
working area. The cable and any extensions
must always be behind the machine and the end
user.
Always hold the cable extension in the hook
provided on the machine.
Connect this machine to alternate
current 120V/60Hz.
Do not touch this machine with wet hands. Risk
of electric shock. Maintain the cable well clear
of the moving element at all times.
Do not use this machine if the ¨open¨ and
¨closed¨ switch does not work. Any electric
4/52
and
2