Ignition Coil - ICS 680ES Manual De Mantenimiento

680ES SERVICE MANUAL
15. This section covers the removal, inspection, and installation of the ignition
coil. Removal of the starter is required. Refer to section 8 if necessary.
15.1
Remove starter flywheel shroud by
unhooking wires.
15.2
Remove ignition coil screws, wave
washers and plain washers.
15.3
Remove ignition coil.
15.4
Inspect.
A. Look for cracks/missing insulation.
B. Clean flywheel magnets and coil if
rusty.
© 2020 ICS- Blount Inc Specifications and pricing are subject to change without notice. P/N 598000 REV01162020

15. IGNITION COIL

53