Designated Use; Ambient Conditions - Cleco NeoTek 30EA Serie Manual De Instrucciones

Specific safety instructions for Hand-Held
Electric Nutrunner
a) Do not exceed a total cable length of 115 ft. (45 m).
b) The wearing of gloves is prohibited.
c) Grip tool firmly in your hand. Be prepared for rapid
changes in reaction torque.
d) When using the tool in confined spaces and with torques
in excess of
• 3 ft.lbf (4 Nm) for straight tools
• 7 ft.lbf (10 Nm) for pistol/gun tools
• 44 ft.lbf (60 Nm) for angle tools
Always use a reaction bar. When in use, never place
your hand on the reaction bar.
e) Check that the suspension bail is properly secured to the
tool and balancer.
3 Use and handling of a Hand-Held Electric
Nutrunner
a) Only use fastener drive tools (sockets, nutsetters, etc...)
that were designed for industrial applications.
b) Make sure that the fastener drive tool is securely attached
to the output spindle.
c) Do not attempt to drive fasteners with the tool at an angle
to the work piece.
d) Never use a high-pressure cleaner to clean the tool.
e) Do not immerse tool in cleaning agent.
4

Designated use

This product is part of the Cleco tightening system and is
designed exclusively for fastening and releasing threaded
fasteners.
→ Only use in conjunction with a control series
mPro400GCD-P, accessories and tool cable supplied by
Cleco.
→ Do not use as a hammer for aligning or re-bending
components.
→ Do not open it or modify it structurally.
→ Do not use it in areas where there is a risk of explosion.
5

Ambient Conditions

Function Temperature
Transport / -4°F to +158°F
Storage (-20°C to +70°C)
+32°F to +113°F
Operating
(0°C to +45°C)
Relative Working
Humidity Height
up to 9800 ft.
0...90%
(3000 m)
non-condensing
above sea level
EN
Page 9
TM12-1109-LG1
08/25/2017