Benchtop Base Assembly - Kreg Jig Manual De Instrucciones

Benchtop Base Assembly

5
Attach the Clamping Pad
1. Attach the Clamping Pad to the Clamp Follower
by simply threading the shaft of the Clamping Pad
into the threaded insert of the Clamp Follower.
2. The position of the Clamping Pad will be
adjusted for the thickness of the material to
be drilled. Proper position of the Clamping Pad
will be outlined in the "Getting to Know Your
K3 System" section.
3. You may notice that the Clamping Pad will
angle slightly upward once the Clamping Pad
is installed into the Clamp Follower. This is the
correct configuration of the Clamping Pad. The
Clamping Pad is angled slightly upward to assist
the clamping mechanism to insure the work
piece is seated tight against the Drill Guide Block
and flush with the Benchtop Base surface.
Attach the Index Pin
(Fig. 5C)
1. Thread the Brass Index Pin into the threaded
insert contained in the upright of the
Benchtop Base.
2. Back off the Brass Index Pin so that the rounded
point of the Brass Index Pin is flush with the inside
of the upright surface.
3. The Brass Index Pin will be seated fully when the
Drill Guide Block has been inserted in the opening of
the upright and used to hold the Drill Guide Block
in position prior to clamping.
Store the Allen Wrench
1. The 1/8" Allen Wrench is used to lock the
Depth Collar in position on the Kreg Jig
Bit for different depths of pocket holes.
2. The Allen Wrench may be stored either in the
designated location in the case or it can be held
conveniently in the rear of the Clamp Follower.
3. When using the Clamp Follower location be
sure to rotate the right-angled extension of
the Allen Wrench to a clock position between
9 o'clock and 3 o'clock. This will prevent the
Allen Wrench from being accidentally lost when
the Clamp Follower slides across the center rib
in the bottom of the Benchtop Base.
(Fig. 5A&B)
(Fig. 5D)
Drill
®
Hex nut on threaded shaft.
Clamping Pad clamped against board.
Inserting the Brass Index Pin.
Storage for the Allen Wrench.
Fig. 5A
Fig. 5B
Fig. 5C
Fig. 5D