Installing Your Appliance; Electric Connection - Beko CWB 6460 X Manual Del Usuario

2

Installing your appliance

Assembly and electrical connections must
•
be carried out by specialized personnel.
Wear protective gloves before proceeding
•
with the installation.

Electric Connection:

Note! Verify the data label placed inside the ap-
pliance:
If the symbol appears on the plate, it means
•
that no earth connection must be made on the
appliance, therefore follow the instructions con-
cerning insulation class II.
If the symbol DOES NOT appear on the
•
plate, follow the instructions concerning insu-
lation class I.
Insulation class II
The appliance has been manufactured as a
•
class II, therefore no earth cable is necessary.
The plug must be easily accessible after the
installation of the appliance.
If the appliance is equipped with power cord
•
without plug, a suitably dimensioned omnipolar
switch with 3 mm minimum opening between
contacts must be fitted between the appliance
and the electricity supply in compliance with
the load and current regulations.
The connection to the mains is carried out as
•
follows:
BROWN = L line
BLUE = N neutral.
Insulation class I
This is a class I, appliance and must therefore be
connected to an effiecient earthing system.
The appliance must be connected to the elec-
•
tricity supply as follows:
8 / 27 EN
BROWN = L line
BLUE = N neutral.
YELLOW/GREEN =
The neutral wire must be connected to the ter-
minal with the N symbol while the YELLOW/
GREEN, wire must be connected to the terminal
by the earth symbol
When connecting the appliance to the electricity
supply, make sure that the mains socket has an
earth connection. After fitting the ducted cooker
hood, make sure that the electrical plug is in a
position where it can be accessed easily. If the
appliance is connected directly to the electricity
supply, an omnipolar switch with a minimum con-
tact opening of 3 mm must be placed in between
the two; its size must be suitable for the load re-
quired and it must comply with current legislation.
TIf the hob is electric, gas, or induction, the
•
minimum distance between the same and the
lower part of the hood must be at least 65 cm.
If a connection tube composed of two parts is
used, the upper part must be placed outside
the lower part. Do not connect the cooker hood
exhaust to the same conductor used to circu-
late hot air or for evacuating fumes from other
appliances generated by other than an electri-
cal source. Before proceeding with the assem-
bly operations, remove the anti-grease filter(s)
(Fig.5) so that the unit is easier to handle. In
the case of assembly of the appliance in the
suction version prepare the hole for evacuation
of the air.
We recommend the use of an air exhaust tube
•
which has the same diameter as the air exhaust
outlet hole. If a pipe with a smaller diameter
is used, the efficiency of the product may be
reduced and its operation may become noisier.
If your appliance has been designed for use in
•
habitations supplied with acentralised suction
device perform the following operations:
earth.
.
Cooker Hood / User Manual