Fixing To The Wall; Filtering Version - Beko CWB 6460 X Manual Del Usuario

2 Installing your appliance
The switch controls opening and closure of a
•
valve using a thermoelectical device. By placing
the switch in the ON position, after a minute,
the valve opens rotating 90° allowing suction
of the stale air. By placing the switch in the OFF
position, the valve closes after 100 seconds.

Fixing to the wall:

Drill the holes A respecting the distances indicat-
ed (Fig.2). Fix the appliance to the wall and align
it in horizontal position to the wall units. When
the appliance has been adjusted, definitely fix the
hood using the screws A (Fig.4). For the various
installations use screws and screw anchors suited
to the type of wall (e.g. reinforced concrete, plas-
terboard, etc.).
If the screws and screw anchors are provided with
the product, check that they are suitable for the
type of wall on which the hood is to be fixed.
Fixing the decorative telescopic flue:
Arrange the electrical power supply within the
dimensions of the decorative flue. If your appli-
ance is to be installed in the ducting version or
in the version with external motor, prepare the air
exhaust opening. Adjust the width of the support
bracket of the upper flue (Fig.3). Then fix it to the
ceiling using the screws A (Fig.3) in such a way
that it is in line with your hood and respecting the
distance from the ceiling indicated in Fig.2. Con-
nect the flange C to the air exhaust hole using a
connection pipe (Fig.4). Insert the upper flue into
the lower flue and rest above the frame. Extract
the upper flue up to the bracket and fix it with
the screws B (Fig.3). To transform the hood from
a ducting version into a filtering version, ask your
dealer for the charcoal filters and follow the instal-
lation instructions.
Cooker Hood / User Manual

Filtering version:

Install the hood and the two flues as described in
the paragraph for installation of the hood in duct-
ing version. To assemble the filtering flue refer to
the instructions contained in the kit. If the kit is
not provided, order it from your dealer as acces-
sory. The filters must be applied to the suction unit
positioned inside the hood. They must be centered
by turning them 90 degrees until the stop catch is
tripped (Fig.6).
9 / 27 EN