Cleaning The Cyclone Air Filter - Toro 22602 Manual Del Usuario

Cleaning the Cyclone Air Filter

The cyclone air filter collects the largest contaminant particles, which collect in the container.
When you can see a layer of dirt at the bottom of the container, the cyclone housing (4), air
channels and air intake screen (3) must be cleaned.
1. Remove the three screws holding the
cyclone housing.
2. Remove the housing with the air intake
screen and remove the air channels.
Note: The air channels may remain in the upper
portion or follow along with the housing when
removed.
3. Clean the components. Use water, detergent
and a brush. Dry carefully.
4. Place the air channels in the cyclone
housing.
5. Insert cyclone housing into position and
make sure it fits in the upper portion.
DO NOT use force; align it in place before
fitting the screws.
20