Brandt BFC8612NW Manual Del Usuario página 47

Daily Use
Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of
competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not
work
Appliance freezes or
cools too much
The food is not frozen
enough.
Heavy build-up of frost
on the door seal.
Unusual noises
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer to
the rating plate.
Possible cause
Mains plug is not plugged in or is
loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or the
appliance runs at Super modes.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat source.
Door seal is not air tight.
Appliance is not level.
The appliance is touching the wall or
other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or the
wall.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator to a
warmer setting temporarily.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to a
colder setting temporarily.
Please look in the installation
location section.
Carefully warm the leaking sections
of the door seal with a hair dryer (on
a cool setting). At the same time
shape the warmed door seal by
hand such that it sits correctly.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
20
Solution