Cleaning And Routine Maintenance - EAS ELECTRIC EMTD8HP Manual

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning and routine maintenance

Empty the water container
1. Hold and pull out the water container
with two hands;
2. Tilt the water container, pour out the
condensed water into basin;
3. Install the
water container.
WARNING:
Empty the water container after each use, the programme will be paused and the Full
1.
LED will light if the water container is full during the drying process. After the container
emptyed, the dryer can be restarted by pressing
2.Do not drink the condensed water
3.Do not use the dryer without the water container
Clean the filter door
1.Open the door.
2.Take out the filter door.
3.Clean the filter door; wipe off the scrap threads
accumulated on the filter door.
4.Reinstall the filter door.
(Only EMTD8HP)
Clean filter base
1.Open the maintenance cover.
2.Unscrew both locking levers towardas each other.
3.Clean the filter base completely.
4.Re-insert the filter base!
5.Screw both locking levers.
6.Close the
maintenance cover
until it locks into position.
NOTE!
1.The fluff accumulated on the filter will block the air circulation,
which will cause the extension of drying time and energy consumption;
2.Do disconnect the power cord before cleaning!
3.Do not operate the dryer without the filter!
4.Clean the filter after each use to prevent lint accumulation inside the dryer.
(Only EMTD8HP)
Clean heat exchanger
As necessary, approx. once every 2 months, remove the fluff from
the heat exchanger using the sponge or soft brush.
When doing this, please use gloves.
Note: The fluff can be removed more easily if it is first
dampened e. g. with a laundry dampener.
V.1
Start/Pause
button.
.
Filter door
Locking lever
16
Cleaning and routine maintenance
Wash air condenser
-Leave the dryer to cool down.
-Residual water may escape, place an absorbent
cloth under the maintenance cover.
1.Unlock the maintenance cover.
2.Completely open maintenace cover.
3.Screw both locking levers towardas each other.
4.Pool out the air condenser.
5.Clean the air condenser completely, drain thoroughly.
6.Clean the seals.
7.Re-insert the air condenser, handle at the button!
8.Unscrew both locking levers.
9.Cloth the maintenance flap until it locks into position.
Please clean the air condenser approx, once every 3
months if frequently used.
Do not damage the air condenser!
1.Clean with water only; do not use hard/sharp-edged objects!
!
Do not operate the dryer without the air condenser!
2.During drying, water may
but this does not affect the function of your dryer!
Filter base
Maintenance cover
(Only EMTD8CB)
collect between the window
and the seal,
17
V.1

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Emtd8cb

Tabla de contenido