FileCruiser VA2600 Guia De Inicio Rapido página 10

Promise Technology
To install the FileCruiser into a rack with the supplied mounting rails:
1. Check the fit of the mounting rails in your rack system.
2. Adjust the length of the mounting rails as needed.
The rear rail slides inside the front rail. The rail halves are riveted together and
use no adjustment screws.
The front-left and front-right mounting rail ends are labeled.
Be sure the front rail support is on the bottom facing inward.
Figure 3: Installing the rails onto the rack
Front left label
Support flange on the front
end of each rail
All rail ends, front and rear, attach at the outside of the rack posts.
The guide pins at the rail ends align with the holes in the rack posts.
Use the attaching screws and flange nuts from your rack system. Tighten the
screws and nuts according to instructions for your rack system.
Front right label
Guide pins on rails align
with holes in the rack post
8