Task 2: Mounting Filecruiser In A Rack - FileCruiser VA2600 Guia De Inicio Rapido

TASK 2: MOUNTING FILECRUISER IN A
RACK
The instructions here apply to the FileCruiser VA2600.
Cautions
Do not populate any unit with hard drives until it has been securely
*
installed in the rack.
At least two persons are required to safely lift, place, and attach the
*
FileCruiser unit into a rack system.
* Do not lift or move the FileCruiser unit by the handles, power
supplies or the controller units. Hold the system itself.
Do not install the FileCruiser unit into a rack without rails to support
*
the system.
Only a qualified technician who is familiar with the installation
*
procedure should mount and install the FileCruiser unit.
Mount the rails to the rack using the appropriate screws and flange
*
nuts, fully tightened, at each end of the rail.
* Do not load the rails unless they are installed with screws as
instructed.
The rails available for the PROMISE FileCruiser unit are designed to
*
safely support that PROMISE FileCruiser unit when properly
installed. Additional loading on the rails is at the customer's risk.
PROMISE Technology, Inc. cannot guarantee that the mounting
*
rails will support your PROMISE FileCruiser unit unless you install
them as instructed.
The enclosure installs to the rack using the mounting rails shipped with the device.
Note
To lighten the enclosure, you can remove the power supplies. Replace
the power supplies after the FileCruiser unit is mounted in your rack.
FileCruiser VA2600 Hardware Installation Guide
7