Worx WG604 Manual Del Usuario página 11

MAINTENANCE
Remove Plug from the socket before carrying out any adjustment, servicing or maintenance.
Inspect the product for damaged or worn parts before each use. Do not operate it if you find damaged or
worn parts. Contact your supplier or the manufacturer for replacement parts.
Power cord maintenance
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali-
fied persons in order to avoid a hazard
Pump maintenance
Inspect the pump frequently whether any leaking occurs around the pump seal. If leaking occurs, please
contact service center for repair.
Nozzle maintenance
Remove the nozzle from the lance, then remove any possible obstructions using the included declogging
needle(See Fig.M)..Then use a garden hose to rinse the nozzle by backwashing.
WARNING: Any other servicing should be performed by an authorized service representa-
tive.
STORAGE
1. Disconnect the water source.Turn on the pressure washers for a few seconds until the remaining water
flows out.Then turn it off quickly.
2. Unplug the power supply and hang it on the Power Cord Holder .
3. Disconnect the high pressure hose and the garden hose (not supplied) .Then wind high pressure hose.
Insert the Wand into the Wand Holder. ( See Fig N)
4. Store in a frost free area with a temperature above 0℃(32
13A Electric Pressure Washer
F).
O
11
EN