Fanimation AIRE DELUXE FP6284 Serie Manual De Instrucciones página 13

How to Assemble Your Switch Cup Assembly/Light Kit Assembly
(Continued)
3A—FP6284**. Securely attach the 9-pin connector from
the motor assembly to the wire harness socket within the
switch cup assembly. (Figure 3A)
3B—FP6285B**. Securely attach the 9-pin connector from
the motor assembly to the wire harness socket within the
light kit assembly. (Figure 3B)
The color label on these two connectors must
correspond to each other.
4A—FP6284**. Assemble the switch cup assembly to
the switch housing adapter using the previously removed
screws and securely tighten all screws. (Figure 4A)
4B—FP6285B**. Assemble the light kit assembly to the
switch housing adapter using the previously removed
screws and securely tighten all screws. (Figure 4B)
NOTE: If you have installed your fan without light kit (FP6284**)
skip Steps 5 and 6.
5. Insert light bulbs into sockets. (Figure 5)
NOTE: When relamping is required, USE ONLY
MAX 9W, TYPE E26 DIMMABLE LISTED LED
(LIGHT) BULB.
RISK OF FIRE. USE ONLY LED LAMPS IN THIS
LIGHT KIT. INCANDESCENT AND HALOGEN LAMPS
MAY CAUSE SEVERE THERMAL DAMAGE.
6. Disassemble the finial, trim cover and nut in light kit
assembly. Securely attach the glass to light kit assembly
using supplied nut, trim cover and finial. Do not over
tighten. (Figure 6)
WARNING
CAUTION
FP6284**
Switch Cup Assembly
Figure 3A
FP6284**
Switch Cup
Assembly
Figure 4A
Bulb
Light Kit Assembly
13
FP6285B**
Motor
Assembly
Light Kit Assembly
Figure 3B
FP6285B**
Figure 4B
Figure 5
Glass
Nut
Trim Cover
Finial
Figure 6
Motor
Assembly
Light Kit
Assembly
Light Kit
Assembly