MarelliMotori MEC-100 Manual De Instrucciones página 80

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

To start the MEC-100 Interface System you must select I accept the contract terms and then click on the Next
button.
READ CAREFULLY THE GENERAL CONTRACT CONDITIONS.
Perform the above-mentioned operations to start the program involves the SIGNING and FULL
ACCEPTANCE by the user of the there described terms and conditions.
5.3.2. Description of the Work Window
After you have started the MEC-100 Interface System as described in Para. 5.2.3 and 5.3.1, the equipment will display the work
window allowing to configure and monitor the regulation system parameters. Fig. 5.3.2.a. shows the displayed screen:
3
4
5
2
It includes the following elements:
1.
System monitoring area: displays in real time the values relative to the electrical system data, the status of contacts and
alarms.
2.
Generator parameter area: set of pages dedicated to the system configuration. It includes the fields where to assign the
appropriate values to all parameters involved in the system configuration. The parameters are grouped by type in 9
Categories (system data, sensing, setpoints and other settings, stability, limitation parameters, protections, field and
generator, diode monitoring).
3.
MEC-100-PC communication area: area for the management of the communication between MEC-100 and PC. It shows in
real time the communication status.
4.
Setpoint variation buttons: tools for the modification of the controlled quantity setpoint (voltage, power factor or reactive
power depending on the actual operating mode).
5.
Group selection area: frame to select the desired configuration window.
6.
Oscillographic tracing of a system quantity.
7.
Electrical system parameter monitoring.
8.
System status window.
9.
Alarm window.
963857137_G
Fig. 5.3.2.a
MEC-100 Interface System Work Window
6
MEC-100
1
7
8
9
80

Publicidad

Tabla de contenido
loading

Tabla de contenido