Unpacking Instructions - Fanimation ZONIX MA4660 Serie Manual

This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• One ¼˝ blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 10). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in fi nding your place should you be interrupted.
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
Downrod/
Hanger Ball
Assembly
Motor Assembly
All manuals and user guides at all-guides.com
• One wire stripper
• One hex wrench

Unpacking Instructions

Motor Coupling Cover
Screw Cover
Switch Cup Cover Switch Cup Cover
Assembly Assembly
(MA4660**) (MA4660SSBNW)
Materials
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
• Motor Assembly
• Downrod/Hanger Ball
Assembly
• Hanger Bracket
• Ceiling Canopy
• Canopy Screw Cover
• Motor Coupling Cover
• Switch Cup Cover Assembly
• Receiver Unit
• Hand-Held Remote
Canopy
Ceiling Canopy
Receiver Unit
4
Wire Size A.W.G.
14
12
• Hardware bags:
– Ten 3/16˝-24 (blade to motor hub)
Serrated head screws & stainless
flat washers
– Four wire connectors
– Blade Balance Kit
– Two #8-32 junction box screws,
stainless steel
– Two Flat Washer, stainless steel
– Bag Assembly Safety Cable
Hanger Bracket
Hand-Held Hardware Bags
Remote