Chopin Rheo F4 Instalación Rápida página 4

3. Starting the test
To start the test, click on Test > Start or directly on the [Start test] icon:
The test management window will come up. Click on the [TEST]
button to start the measures.
The test begins, the [TEST] button becomes [STOP].
From this point on, the test is managed automatically.
Stand-by mode on the computer must be completely
deactivated. Data acquisition lasts for 3 hours.
4. During the test
5. End of the test
A. Stop and clean
Once the test has been completed, the RHEO F4 will indicate it through a pop-up message screen.
The test can be saved by clicking on the [Save] button.
After each test, disconnect and clean:
- the basket and the weights with a damp sponge
- the bowl and the rubber O-ring with a damp cloth
B. Results
The final results are shown at the end of the test.
For the detailed description of the measured and calculated
parameters, see pages 30 and 31 of the user's manual.
Up to 5 tests can be compared by clicking on this
button:
The results can be printed directly as a
certificate of analysis by clicking on this
button.
Choose the protocol and then enter the name of the test.
Validate.
Results come up in real time throughout the all test.
While the test is going on, it can be compared to
a reference curve by clicking on this icon::