Loading Data - RCBS BRASS BOSS 90390 Instrucciones Del Producto

Because RCBS
other reloading equipment, RCBS assumes no liability, expressed or implied, for the

LOADING DATA

Use only laboratory tested reloading data. We highly recommend the current SPEER Reloading Manual.
OBSERVE ALL WARNINGS ABOUT THE USE OF MAXIMUM LISTED LOADS.
WORKING WITH CARTRIDGE CASES
• Examine empty cases to be sure they are in good condition before reloading. Thin, split, deformed,
or badly corroded or pitted cases may be structurally weak, and result in a dangerous condition. Pay
particular attention to splits in the mouth, separation between the case and the head, and dents in the
shoulder.
• Do not store cartridge cases or ammunition near harsh chemicals such as gasoline, household cleaners
or cat urine. The fumes can weaken the metal and present a dangerous condition.
• Do not clean cases with chemicals other than those specifically designed for the purpose.
• Do not attempt to clean loaded ammunition or primed cases. Doing so can cause corrosion, and weaken
the case, or cause a misfire/hangfire condition.
• Ensure cases have proper primer pocket sizes; remove primer staking/crimp if necessary. Attempting to
seat a primer into an undersized pocket or pocket with staking/crimping can result in detonation.
• Do not ream out or enlarge flash holes of cartridge cases. This may change the ignition rate and result
in dangerous pressures.
• Resize and trim fired cases to ensure reliable chambering and obtain proper projectile tension and
crimp.
• Never attempt to guess at the identity of your ammunition.
Reloading is an enjoyable and rewarding experience. This case prep center will add to the quality of your
reloads. It has been designed from the beginning with the user's safety in mind.
As with any mechanical device, some safety, rules must be followed. By observing these rules, the chance of a
hazardous occurrence becomes extremely remote.
ELECTRICAL WARNINGS
DANGER OF ELECTRIC SHOCK! To prevent life-threatening electric shock, please observe the
following:
• This product is equipped with a three wire, grounded power cord; plug only into a proper outlet.
• Do not work on wet floors.
• Do not plug into electrical outlet until the proper voltage is supplied.
• Locate all electric cords away from moisture, rain and moving parts.
• Periodically check all cords for worn/frayed spots and replace or repair cord if needed.
• Never use unit if power cord becomes damaged.
• Always disconnect power cord before adjusting, cleaning, setup, etc.
• Always unplug unit when not in use.
• Do not use while bathing.
• Never immerse the device or power cord in water or other liquid.
has no control over the choice, assembly or use of components or
®
product produced from reloading with this equipment.
3
English