RCBS BRASS BOSS 90390 Instrucciones Del Producto página 6

A variety of optional accessories are also available for the Brass Boss. See your dealer or call us at RCBS for more
information about the following optional accessories:
• Carbide Primer Pocket Uniformer, small rifl e, part #90379
• Carbide Primer Pocket Uniformer, large rifl e, part #90378
• Carbide Primer Pocket Uniformer, large pistol, part #90383
• Military Crimp Remover -2, small part #90386
• Military Crimp Remover -2, large part #90387
• Carbide Chamfer Tool, part #90384
• Carbide Debur Tool, part #90385
• 50 BMG Military Crimp Remover, part #09562
• 50 BMG Carbide Primer Pocket Uniformer, part #09561
• Flash Hole Deburring Tool (see catalog for part numbers)
Place the Brass Boss in a convenient spot on your reloading bench.
USING THE BRASS BOSS
Circular pattern (clockwise), starting at 12:00 position, label the stations as follows:1, 2, 3, 4, 5, 6
Top two Brass positions left 7, right 8
Install the tools when the Brass Boss is turned off and unplugged from power.
Most of the accessories for the Brass Boss can be installed in any one of the six rotating stations located
on the unit. However, some accessories will be more convenient and easier to use if they are installed in
certain positions-more details will be provided in the sections covering specifi c accessories/tools. Use this
photo as a guide for installing the various cutters, cleaners, brushes and uniformers. Also, to make it easier for
identifi cation, we have numbered the stations in the photograph.
7
1
6
5
4
8
2
3
6