Magic Chef MCSCD6W1 Manual Del Usuario página 20

2) Select the desired wash cycle sequence by pressing the program button.
3) Press the START/RESET button again to resume operation using the newly
selected wash cycle sequence.
NOTE: If you change the wash cycle sequence after the detergent has been dispensed,
or the dishwasher has already drained the water, you will need to refill the detergent
dispenser for the newly elected wash cycle sequence, accordingly.
END OF THE WASH CYCLE PROCEDURE
Once the dishwasher has completed the selected wash cycle sequence, a buzzer will
sound for 8 seconds, indicating the end of they wash cycle.
1) Shut off the water supply.
2) Turn the dishwasher OFF by pressing the ON/OFF button.
3) Open the door ajar slowly to allow residual steam to escape.
4) Wait a few minutes (approximately 15 minutes) before unloading the dishwasher
as the dishes and cutlery will be hot. This also aids in the drying process.
5) The interior of the dishwasher will be wet, this is normal and will dry naturally.
It is dangerous to open the door when the dishwasher is in operation,
as the hot water may cause scalding or injury.
CHECKING THE WATER TEMPERATURE
For the most effective cleaning and to prevent damage to the dishware being cleaned,
the hot water supplied to the dishwasher should be at a temperature of at least 120oF
(49oC) and no more than 150oF (66oC).
20